AM AM radio broadcast stations in 2006 AM stations were the earliestradio broadcasting stations to be developed. AM refers to amplitude modulation, a mode of broadcasting radio waves by varying the amplitude of the carrier signal in response to the amplitude of the signal to be transmitted. The medium-wave band is used worldwide for AM broadcasting. Europe also uses the long wave band. In response to the growing popularity of FM radio stereo radio stations in the late 1980s and early 1990s, some North American stations began broadcasting in AM stereo, though this never gained popularity, and very few receivers were ever sold. One of the advantages of AM is that its signal can be detected (turned into sound) with simple equipment. If a signal is strong enough, not even a power source is needed; building an unpowered crystal radio receiver was a common childhood project in the early decades of AM broadcasting. AM broadcasts occur on North American airwaves in the medium wave frequency range of 530 to 1700 kHz (known as the "standard broadcast band"). The band was expanded in the 1990s by adding nine channels from 1620 to 1700 kHz. Channels are spaced every 10 kHz in the Americas, and generally every 9 kHz everywhere else. The signal is subject to interference from electrical storms (lightning) and other electromagnetic interference (EMI). AM transmissions cannot be ionospherically propagated during the day due to strong absorption in the D-layer of the ionosphere. In a crowded channel environment this means that the power of regional channels which share a frequency must be reduced at night or directionally beamed in order to avoid interference, which reduces the potential nighttime audience. Some stations have frequencies unshared with other stations in North America; these are called clear-channel stations. Many of them can be heard across much of the country at night. This is not to be confused with Clear Channel Communications, merely a brand name, which currently owns many U.S. radio stations on both the AM and fm broadcast bands. During the night, this absorption largely disappears and permits signals to travel to much more distant locations via ionospheric reflections. However, fading of the signal can be severe at night. AM radio transmitters can transmit audio frequencies up to 15 kHz (now limited to 10 kHz in the US due to FCC rules designed to reduce interference), but most receivers are only capable of reproducing frequencies up to 5 kHz or less. At the time that AM broadcasting began in the 1920s, this provided adequate fidelity for existing microphones, 78 rpm recordings, and loudspeakers. The fidelity of sound equipment subsequently improved considerably, but the receivers did not. Reducing the bandwidth of the receivers reduces the cost of manufacturing and makes them less prone to interference. fm broadcast transmitter are never assigned adjacent channels in the same service area. This prevents the sideband power generated by two stations from interfering with each other.[7] Bob Carver created an AM stereo tuner employing notch filtering that demonstrated that an AM broadcast can meet or exceed the 15 kHz baseband bandwidth alloted tobest radio transmitter stations without objectionable interference. After several years, the tuner was discontinued. Bob Carver had left the company and the Carver Corporation later cut the number of models produced before discontinuing production completely.